Am I losing my mind? Can someone tell me what I am doing wrong?
Hello,
Thanks for reading, I hope that you can give me some piece of mind and figure out what is going on.
Basically, I am trying to set up a buy button, which then changes to upgrade. The buy/upgrade button changes an attribute, another actor then changes an image depending on that attribute. The attribute is initialized at 0, each time the actor/button is pressed it should increment until it reaches 5, at which point everything is finished.
Now the button works almost as expected, however after pressing the very first Buy button, it immediately jumps to 2.
I have a lot of experience in objective c programming, and I know simple mistakes like this are very easy to make. No matter how hard I try I cannot figure out why its not working as intended, hopefully someone smarter than I can explain why it behaves like this, and a work-around for it.
http://d.pr/IGZV/3KZatYuq
That is the behaviors as outlined above.
Thanks Again, if you need any further detail ask away.
Thanks for reading, I hope that you can give me some piece of mind and figure out what is going on.
Basically, I am trying to set up a buy button, which then changes to upgrade. The buy/upgrade button changes an attribute, another actor then changes an image depending on that attribute. The attribute is initialized at 0, each time the actor/button is pressed it should increment until it reaches 5, at which point everything is finished.
Now the button works almost as expected, however after pressing the very first Buy button, it immediately jumps to 2.
I have a lot of experience in objective c programming, and I know simple mistakes like this are very easy to make. No matter how hard I try I cannot figure out why its not working as intended, hopefully someone smarter than I can explain why it behaves like this, and a work-around for it.
http://d.pr/IGZV/3KZatYuq
That is the behaviors as outlined above.
Thanks Again, if you need any further detail ask away.
Comments
I don't have time right now, but if no one else has looked in to it by tomorrow, I'll take a look.
- Thomas
It's going through the first rule, which changes the attribute to 1. That makes the second rule true and therefor adds another one.
Thank you very much, worked first time!