Interpolate questions?
Tiny_Ideas
Member Posts: 326
Hi everyone,
I have been looking into interpolates a lot more after I found out Move To behaviour doesn't work.
But have some questions about:
- can an interpolate be interrupted half way through if the variables were to change?
- if x position is interpolating left , then half way through have a new interpolate behaviour going right is it meant to cancel each other out?
- Is there a glitch in the last few frames if the interpolate, I noticed when fading it seems to jump at the end, I read a work around, but is there one for movement?
- is it possible to make it so when only using one (1) interpolate behaviour, and by adjusting variables, an actor can go left then back to its originally position. All in the one interpolate?
That's all for now, keep on developing
Jeromy
I have been looking into interpolates a lot more after I found out Move To behaviour doesn't work.
But have some questions about:
- can an interpolate be interrupted half way through if the variables were to change?
- if x position is interpolating left , then half way through have a new interpolate behaviour going right is it meant to cancel each other out?
- Is there a glitch in the last few frames if the interpolate, I noticed when fading it seems to jump at the end, I read a work around, but is there one for movement?
- is it possible to make it so when only using one (1) interpolate behaviour, and by adjusting variables, an actor can go left then back to its originally position. All in the one interpolate?
That's all for now, keep on developing
Jeromy Best Answer
-
gyroscope I am here.Posts: 6,598
For easiness, I'll upload the file again here in this thread for you and anyone else who might find it useful:
A test, suggestion on how to stop an interpolate "mid-flight"
Answers
Hi @Jeromy
This question has been asked a few times before in the Forums.... (but then, for those of us who've been around here for 3 or 4 years, we could say - what question hasn't?
Here's one thread discussing interrupting an Interpolate behaviour, and in one of my posts there I've included a test file of one way to do that. Hope it helps.
http://forums.gamesalad.com/discussion/comment/361704/#Comment_361704